|
|
#1
03-23-2008, 09:24 AM
|
|||
|
|||
Quick Fair...Epoxy Coat?
Just got my quick fair in and noticed on the can it states:
Before painting this product must be coated with epoxy resin. For you out there using this product, have you been doing this?
__________________
[SIGPIC][/SIGPIC] "If You Done It...It Ain't Braggin" my rebuild thread: http://www.classicseacraft.com/commu...ad.php?t=18594 
|
|
#2
03-23-2008, 01:31 PM
|
|||
|
|||
|
Re: Quick Fair...Epoxy Coat?
Is it system 3 quick fair? If so then you can sand and spray over it with awlgrip 545 primer and then paint over that.
strick
__________________
"I always wanted to piss in the Rhine" (General George Patton upon entering Germany)
|
|
#3
03-23-2008, 08:58 PM
|
|||
|
|||
|
Re: Quick Fair...Epoxy Coat?
Yes it is Systems 3...I got it based on your post. It is on there label, so I was wondering if you had to do it.
Now if I read your answer you did not epoxy over it first and every thing is OK.
__________________
[SIGPIC][/SIGPIC] "If You Done It...It Ain't Braggin" my rebuild thread: http://www.classicseacraft.com/commu...ad.php?t=18594
|
|
#4
03-25-2008, 11:14 AM
|
|||
|
|||
|
Re: Quick Fair...Epoxy Coat?
Well in essence I did. The awlgrip 545 is an epoxy based primer.
Rule of thumb is that you cannot put polyester over epoxy but you can epoxy over polyester....therefore since system 3 quick fair is a epoxy based product anything you put over it must also be an epoxy based product. strick
__________________
"I always wanted to piss in the Rhine" (General George Patton upon entering Germany)
|
 |
|
|
Linear Mode
