Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 03-15-2009, 08:00 PM
MasterBaiter MasterBaiter is offline
Senior Member
 
Join Date: Sep 2008
Location: New Jersey
Posts: 229
Default 23 inboard wiring

I am getting ready to rip into the mess the previous owner left in my boat and I have a question.

There is a pair of 50 amp breakers mounted to the engine as part of the original harness that have been hacked, spliced, and basically butchered.

Does anyone know what the original intent of these was?
Someone smarter than me put them on there, but I can't figure it out.

Thanks for any help.
Chris
Reply With Quote
  #2  
Old 03-16-2009, 04:09 AM
McGillicuddy McGillicuddy is offline
Senior Member
 
Join Date: Dec 2007
Location: 32.77 N, 117.01 W
Posts: 2,184
Default Re: 23 inboard wiring

could be charging system protection, one of them may even have a receiver and a dangling connector somewhere. Make sure all the terminals are clean and the connections are tight at the alternator and the batteries. might have had fusing for each battery bank. good luck
__________________
there's no such thing as normal anymore...
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:22 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft