|
|
#1
04-17-2011, 09:53 PM
|
|||
|
|||
bracket question
I have a 1974 20 center console with a yamaha f150 with a 20 inch shaft. It takes a fair amount of water over the back and I would like to mount a bracket and enclose the transom. Has anybody put a bracket on a 20 with a similar motor(440lbs)? As it is motor sits on the transom at it's original hight. Any insite would be appriciated.
|
|
#2
04-17-2011, 10:02 PM
|
|||
|
|||
|
Re: bracket question
Check out Strick's "Here we go again!" thread. He built his own bracket and takes you on a trip both down and up refurbville like no other person to my knowledge. Worth ten time the time it takes to read it! I think it's close to a thousand or more entries.
Good luck and keep us informed.
__________________
Getting home is more important than getting there! Plan accordingly!
|
 |
|
|
Linear Mode
