Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Performance
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #11  
Old 01-19-2010, 04:28 PM
uncleboo uncleboo is offline
Senior Member
 
Join Date: Sep 2009
Location: Edenton, NC
Posts: 1,583
Default Re: 225 on a 20SF (too heavy?)

If I were in your situation, I would drop it in the water and use a level and tape to , at least, approximate whether it would drain properly. Rest the level on one point of the stern above the drain, hold level, then measure inside the cockpit and outside to the water. You could do this with or without people in the boat. Sounds primitive, but, most of what I do is.
__________________
1975 SF18/ 2002 DF140
1972 15' MonArk/ 1972 Merc 50
http://i833.photobucket.com/albums/z...photos/SC3.jpg
Reply With Quote
  #12  
Old 01-19-2010, 05:14 PM
oldfielder oldfielder is offline
Senior Member
 
Join Date: Jun 2005
Location: Miller Place, NY
Posts: 269
Default Re: 225 on a 20SF (too heavy?)

you'll wind up going out the transom if you re-route the scuppers. . If I'm around one day I may be able to take a look with you. My boat's a little stern heavy with an i/o.
I'd be a little hesitant to exceed max hp, but that's me. Make sure you check that transom real well for flex before you go torquing up that motor too much.
PM me if you have any questions.
Reply With Quote
  #13  
Old 01-19-2010, 09:10 PM
eggsuckindog eggsuckindog is offline
Senior Member
 
Join Date: Mar 2003
Location: Tampa
Posts: 2,354
Default Re: 225 on a 20SF (too heavy?)

Mine is a MA but with the 200 Merc #416 it won't self bail at rest with 2 in the back, not much comes in but full fuel and the baitwell has more effect too. Move forward to the console and its fine and runs out or if one person is upfront no problem. The SF may float higher without heavier cap on it not sure. You can't find much power and stay under 400 though
__________________
Any way you measure it - dumbass is expensive
Reply With Quote
  #14  
Old 01-19-2010, 10:58 PM
BoniB BoniB is offline
Member
 
Join Date: Jan 2010
Location: Babylon, NY
Posts: 36
Default Re: 225 on a 20SF (too heavy?)

Its a boat that I'm thinking about buying and it just happens to have a 225 Evinrude on it. If I were to re-power I'd go with a 115 or 150 I think. The fact that the deck drains go into the bilge bother me. I dont think that was original, and re-piping them may be tough. Should I re-pipe the drain straight down through the hull OR take aft out the transom; I'd rather not go through the transom, how about going out each side?? My thought is to possibly sell the 225 and purchase a 150 or smaller.
__________________
26 Regulator Express
74' 20SF
Reply With Quote
  #15  
Old 01-20-2010, 07:01 PM
oldfielder oldfielder is offline
Senior Member
 
Join Date: Jun 2005
Location: Miller Place, NY
Posts: 269
Default Re: 225 on a 20SF (too heavy?)

Shoot me a message if you want moral support looking at the boat this weekend.
Reply With Quote
  #16  
Old 01-20-2010, 10:19 PM
BoniB BoniB is offline
Member
 
Join Date: Jan 2010
Location: Babylon, NY
Posts: 36
Default Re: 225 on a 20SF (too heavy?)

I may need it OF.

Thanks.
__________________
26 Regulator Express
74' 20SF
Reply With Quote
  #17  
Old 01-23-2010, 10:06 AM
2182 2182 is offline
Senior Member
 
Join Date: Jul 2008
Location: charleston, SC
Posts: 209
Default Re: 225 on a 20SF (too heavy?)

the fact of the matter is you're buying the boat for the hull, not the motor. i went through this same issue a few ywears ago. my 18 had a mercury 200 on it when i bought it. i ran it for two years (after redoing the scuppers and building a new splashwell), then sold it for a smaller motor when the timer was right. i guess what im saying is if you love the boat, get it and deal w/ the motor stuff later. just my .02
Reply With Quote
  #18  
Old 01-26-2010, 03:11 PM
jwclbi jwclbi is offline
Senior Member
 
Join Date: Oct 2006
Location: Surf City N.J.
Posts: 321
Default Re: 225 on a 20SF (too heavy?)

What insurance do you guys with the 225's have? I called several company's and tried to get insurace for my 20 with a 225 and they refused. They also were concerned with the age, 1973. Let me know what you think. Thanks.
Reply With Quote
  #19  
Old 01-26-2010, 06:54 PM
Old'sCool Old'sCool is offline
Senior Member
 
Join Date: Jun 2006
Location: Charleston, SC
Posts: 2,122
Default Re: 225 on a 20SF (too heavy?)

I couldn't get insurance without a survey on my '73. I went with Charter Lakes
Reply With Quote
  #20  
Old 01-28-2010, 11:39 AM
oldfielder oldfielder is offline
Senior Member
 
Join Date: Jun 2005
Location: Miller Place, NY
Posts: 269
Default Re: 225 on a 20SF (too heavy?)

try progressive-i've had excellent luck with them. Thankfully never had to file a claim!
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:05 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft