|
|
#1
07-29-2013, 11:11 AM
|
|||
|
|||
Swivel Rod holder w bracket
Tuna guys!!!!Tigress FT-LAUDERDALE swivel 90 degree Rod holder. ½ inch Aluminum bracket to fit 23 1975 Sea Craft or any 52 inch wide splash well. Works great with bent butt rods for tuna fishing. I used it with a Fenwick 80 bent butt with Penn international 80 W. Rod tip reaches over both gunnels and motors. Since I replaced my transom and cut out the splash well, I can’t use it anymore. It measures 52 inches long by 8 inches wide. I had it held in with wing nuts so I could remove when not tuna fishing. 125.00 + shipping.
|
|
#2
06-18-2016, 07:02 AM
|
|||
|
|||
|
OK how about 100.00 + shipping
|
|
#3
06-18-2016, 12:22 PM
|
|||
|
|||
|
Nice looking barns, Sir. Miss that part of the country.
Vezo, Part II
|
|
#4
06-22-2016, 06:59 PM
|
|||
|
|||
|
barns
That's my boat shed which houses my 23 Sea Craft and truck and tractor. It has served me well and saved money on storage.
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
