|
|
#1
12-01-2009, 03:16 PM
|
|||
|
|||
All new for me 1977 23' Sceptre by Potter Project
I have recently acquired a 1977 23' Sceptre SeaCraft by Potter. I have most all the parts and pieces but they aren't on the boat.. the hull has some nicks and chips in it(previous owner had it glass blasted i think) and there are 2 drilled holes in the bow for drainage why the boat is being "refreshed" and there are some holes from where things were drilled in and rod holders.. there was a kicker on it I'm assuming becuase the holes were glassed over. It has a 305 GM in it. If anyone has any ideas or advice it would be greatly appreciated. I'll try and get some pics up as soon as I can. I am new to ClassicSeaCraft.com and new to boat resoration.. so any input is more then I have
|
|
#3
12-01-2009, 04:27 PM
|
|||
|
|||
|
Re: All new for me 1977 23' Spectre by Potter Project
Thanks, I'm unsure of where to start on it
|
|
#4
12-01-2009, 05:47 PM
|
|||
|
|||
|
Re: All new for me 1977 23' Spectre by Potter Project
basically just start dropping questions. the guys on this site are seacraft gods lol. dont think there is nothing the hasnt been done or tried also the search engine is awesome on here. i got a 1976 I/O 23ft sceptre. love it.
|
|
#5
12-02-2009, 06:04 PM
|
|||
|
|||
|
Re: All new for me 1977 23' Spectre by Potter Project
Good luck with the project.Lot's of good advice on this site,and some absolutely amazing restorations.I have a 1974 23 Tsunami(Scepter)I/O,awesome ride.
You're going to love it when your done.
__________________
All this,just for a boat ride
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
