|
|
#1
03-25-2008, 06:16 PM
|
|||
|
|||
1976 SeaCraft 20 MA with 150hp Mercury 2.0L
1976 SeaCraft 20ft Master Angler with 150hp Mercury 2.0L, New 75 Gallon Fuel Tank in 2005, Hydraulic Steering, Bennett Trim Tabs, Heavy Duty Kicker bracket, Lee stainless outrigger bases, new gauges, breakers and switches. Boat could use some cosmetic fiberglass work around the console . . . some stress cracks typical with a boat from 1976 that's been fished hard. Transom doesn't flex even with the big old aluminum plate that was used to raise it up 5". The boat has a commercial salmon permit . . . but that's pretty much worthless now that there will be no salmon season for the next few years. This would make a great boat for someone. I'm moving back east, so I can't take 2 boats with me
 $6000 or best offer. There is a small soft spot in the casting deck and some uglies around the base of the console. I will be taking care of them this week.        
|
|
#2
03-25-2008, 08:45 PM
|
|||
|
|||
|
Re: 1976 SeaCraft 20 MA with 150hp Mercury 2.0L
compression numbers all right around 115 plus or minus a few PSI.
     
|
|
#4
03-26-2008, 10:06 PM
|
|||
|
|||
|
Re: 1976 SeaCraft 20 MA with 150hp Mercury 2.0L
where is she located?
|
|
#5
03-26-2008, 11:58 PM
|
|||
|
|||
|
Re: 1976 SeaCraft 20 MA with 150hp Mercury 2.0L
Chris - The boat is in Davis, CA.
|
|
#6
03-28-2008, 01:55 AM
|
|||
|
|||
|
Re: 1976 SeaCraft 20 MA with 150hp Mercury 2.0L
Sold! Thanks everyone for your interest.
It's going up to Seattle with Duane.
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
