|
|
#11
07-12-2010, 10:19 AM
|
|||
|
|||
Re: securing bow rail
Over drill the holes and then fill with epoxy. When dry tap in some new holes and you should be done.
__________________
[SIGPIC][/SIGPIC] "If You Done It...It Ain't Braggin" my rebuild thread: http://www.classicseacraft.com/commu...ad.php?t=18594 
|
|
#12
07-12-2010, 10:45 AM
|
|||
|
|||
|
Re: securing bow rail
Island Trader is 100% on the $.
However, I suspect that if the screws pulled out that you have some water damage and that has to be removed. I had some water damage with mine and I removed it from below, glassed in some balsa with NO balsa near rail mounts ( just a lot of extra glass mat in that area and it's perfect )... Only PITA is the rail mounts forward of the bulkhead ( I have a 23' Tsunami ). I don't remember if thru bolts were OEM - but I thru-bolted mine. Good luck.
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
