|
|
#11
01-09-2022, 11:34 PM
|
|||
|
|||
and here is the plan for the gauge cluster
i have a piece of curly teak picked out and ran it through the flush trim router to make a duplicate of the original (or a least a copy of a copy now).  Any suggestions, please let me know. I intend to put a seacraft emblem at the top over the large (speedo and Tach gauge in middle like factory). I'll probably have MPO make it for me. I'm not positive if these are spaced quite right yet. only thing i can do is print and make some templates on scrap and see how it looks. I'll post more pics as I get this done hopefully this week schedule permitting. 2 large are speedo and tach then 2 fuel, volt, tilt, temp, oil small in bottom middle is check engine light 
|
|
|
Threaded Mode