Building a temporary enclosure for working in cold

[TMala]

Just to follow up. I ended up using the frame to a party tent and shrink wrapping over that. I used a $50 propane torch, it got the job done but be sure to get some shrink tape to patch up all your mistakes if it’s your first time! Haha! I then bought a propane heater from Home Depot, I keep it set to low and it will get me 30 degrees above ambient temps.

When I’m working with resin I turn the heater off, it gives me a little more working time and keeps things safe. Then I run a fan to try and ventilate everything for a bit, come back turn on the heater and let things set.