I have a complete 23 Sceptre I/O model in Solidworks that I will give to anyone that wants it. It is pretty big though since it has the engine and Bravo 1X drive models in it too - probably close to 150 Mb. The Solidworks file for the bare hull is 8Mb. Here is a .jpg of it. I built everything in the model pretty much like the boat was built; hull, liner, cap etc. and assembled the components into a Solidworks Assembly. It isn't perfect and there are some small dimensional errors but I think it is surprisingly close given that I have not completely disassembled my 23 for measurements. It would have been a whole lot better if I had used a laser scanner though!!! I can save Solidworks files into other formats like .STEP if that can be imported into AutoCad.
And here is the whole thing...
03-14-2017, 11:24 AM
AutoCAD 23' CC
Linear Mode
