Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Performance
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #11  
Old 05-31-2010, 10:51 PM
eggsuckindog eggsuckindog is offline
Senior Member
 
Join Date: Mar 2003
Location: Tampa
Posts: 2,354
Default Re: Twin Yamaha F115s on a bracketted 23'?

Quote:
I beg to argue Chuck. My 1978 CC with a bracket will plane with a single 115 and that's swinging a 24" ss Suzi prop. You need tabs down, 1 motor tilted slightly and at 4400 rpm's she'll make 14 1/2 knots.

The 115's will make 25.5kts at 4000 rpm's and 39kts at 5950 rpm's. with 3/4 fuel and 2 people. If you have 6 people and lots of ice I see 25kts at 4300 rpms and fast cruise of 32kts at 5k rpm's.......and that's on 9 year old Suzi's!!!!!!!!!
Zukes run a lower gear ratio in the LU, not sure but might make a difference. 2 115's is only 230 at best as they are 4 S Yami's, I don't think its enough either.
__________________
Any way you measure it - dumbass is expensive
Reply With Quote
  #12  
Old 06-01-2010, 08:44 PM
Briguy Briguy is offline
Senior Member
 
Join Date: Apr 2002
Location: Sarasota, Fl
Posts: 976
Default Re: Twin Yamaha F115s on a bracketted 23'?

If your main concern is resale than the single 250 would be the best. It all depends on how much you pay for the 250 and will it make up for the perceived lower value of a boat with twin 115's.

The benefits of the single 250 are lower maintenance cost and of course about 250 pounds less hanging off the rear end. The speed will maybe be 1-2mph across the board better with the single.

If I had to repower it would be hard not to buy the Suzuki 300.
__________________
Capt. Brian

Reply With Quote
  #13  
Old 06-04-2010, 01:28 PM
Snookerd Snookerd is offline
Founding Father
 
Join Date: Feb 2002
Location: Bradenton, FL.
Posts: 2,658
Default Re: Twin Yamaha F115s on a bracketted 23'?

In your area it is not unusual to go 70 miles off fishing. If many of your trips are that far, then the twins with one that will plane is the way to go. AND when fuel goes back to $5.00 plus on the water, more twin 115's will be had. Briguy's 115s are propped right and does 46 mph on GPS. Single 250 or 300 will be the best choice for resale and ride because most people aren't consistently taking a 23 off that far.
__________________
Snookerd
Reply With Quote
  #14  
Old 06-04-2010, 11:48 PM
Briguy Briguy is offline
Senior Member
 
Join Date: Apr 2002
Location: Sarasota, Fl
Posts: 976
Default Re: Twin Yamaha F115s on a bracketted 23'?

I've got more range than guts, that's for sure!
__________________
Capt. Brian

Reply With Quote
  #15  
Old 06-06-2010, 02:54 AM
edloh edloh is offline
Senior Member
 
Join Date: Dec 2004
Location: Houston, TX
Posts: 139
Default Re: Twin Yamaha F115s on a bracketted 23'?

I know the Zuk runs a lower gear ratio, i know of someone with a 23' with twin 115HP suzuki than can plane with one engine too.

if price is good i will go with 2 x 115HP. i have twin 135HP mercury optimax and i could not use all the power. Haven't tried to plance with one engine yet.
Reply With Quote
  #16  
Old 06-06-2010, 05:32 AM
doodlebug doodlebug is offline
Senior Member
 
Join Date: Dec 2006
Location: tampa fl
Posts: 137
Default Re: Twin Yamaha F115s on a bracketted 23'?

mine comes closer to plaining with one 150 than it did
with one of the 250's same props I tried it the first time
I ran it without the hydrofoils on the 150s might plain with the hydrofoils on now
__________________
1979 23 SCEPTRE TWIN 150 Opti's/GAUSE BUILT BRACKET
Reply With Quote
  #17  
Old 06-11-2010, 01:25 AM
edloh edloh is offline
Senior Member
 
Join Date: Dec 2004
Location: Houston, TX
Posts: 139
Default Re: Twin Yamaha F115s on a bracketted 23'?

doodlebug

do you have trim tabs?
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:43 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft