Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Performance
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 07-01-2008, 03:15 PM
Rich Rich is offline
Senior Member
 
Join Date: Mar 2002
Location: Cape Cod
Posts: 622
Default 1988 Yamaha 175 - Bogging down after running

I bought a 20' MA from Honeyhole off this site last year. It has a 1988 Yamaha 175 that has been acting funny. It needed a new steering arm and while I was having that done I had the carbs rebuilt. When I picked it up it ran great until I put it in the water. There was a lot of water in the tank and I had to flush out the fuel water separator a bunch of times. During last season it would always bog down while opening the throttle and could never reach higher RPM's. Originally I thought it was water in the fuel. Over the winter I had the tank drained and a new water separator installed. While staring it up first time this year it ran great, that’s until I put it in the water. The problem still exists. Usually the symptoms are such that when I first drop it in the water and am running out it usually gets up to 4800 - 5000 rpm’s if I’m lucky. After running for awhile it struggles to get past 3900 rpm. While running like this and with the throttle open all of a sudden it may jump up to 4700 again for a brief time. It kind of feels like not all cylinders are firing and if I hit a wave correctly all of a sudden it boosts back up for a brief time.

I have a buddy who has worked on many different OB engines; he has a little marine shop. He has had it and tested everything he knows to test. Decent compression, spark is good, he had it on the muffs for 15 minutes today and it was purring like a kitten, all cylinders firing etc. The last time I was out with it a new problem occurred. While at idol it would suddenly cough and die. Most of the time it would start up again but a couple of times i had to use starting fluid. It still has the issue of reaching higher RPM’s. The oil line was disconnected before I bought the boat and I premix the oil into the tank when I fill up.

Is it possible that there is some sort of electrical issue going on that causes some of the cylinders to stop firing? The cowling has a couple of cracks in the back that could allow a little water in. I have noticed the clips that hold the spark plug wires on the bottom two cylinders are a bit corroded, probably from saltwater getting in through these holes. Could this be a contributing factor? I’m at a loss mainly because my knowledge engine as a whole is not that good.

Any suggestions would be appreciated.

Thanks,

Rich
__________________
Cape Marine Supply
Reply With Quote
  #2  
Old 07-01-2008, 03:26 PM
76Red18 76Red18 is offline
Senior Member
 
Join Date: Apr 2007
Location: NORTH FORT MYERS, FL.
Posts: 671
Default Re: 1988 Yamaha 175 - Bogging down after running

Sounds like there could be gunk in your tank getting sucked up into your fuel pick up tube and restricting flow. Gotta love that ethenol!
__________________
" I'm the one thats got to die when its time for me to die; so let me live my life, the way I want to".
J. M. Hendrix
Reply With Quote
  #3  
Old 07-01-2008, 03:37 PM
76Red18 76Red18 is offline
Senior Member
 
Join Date: Apr 2007
Location: NORTH FORT MYERS, FL.
Posts: 671
Default Re: 1988 Yamaha 175 - Bogging down after running

You could check it out by using a portable tank.
__________________
" I'm the one thats got to die when its time for me to die; so let me live my life, the way I want to".
J. M. Hendrix
Reply With Quote
  #4  
Old 07-01-2008, 04:41 PM
76Red18 76Red18 is offline
Senior Member
 
Join Date: Apr 2007
Location: NORTH FORT MYERS, FL.
Posts: 671
Default Re: 1988 Yamaha 175 - Bogging down after running

Another thought for testing would be to put a vacuum gauge between the fuel/water seperator and motor. I think I'm gonna do that with mine just to keep an eye on filter flow effiency. There should be very little vacuum. Anyone know the correct number?
__________________
" I'm the one thats got to die when its time for me to die; so let me live my life, the way I want to".
J. M. Hendrix
Reply With Quote
  #5  
Old 07-01-2008, 07:00 PM
Fr. Frank Fr. Frank is offline
Senior Member
 
Join Date: Oct 2003
Location: Shalimar, Florida
Posts: 2,265
Default Re: 1988 Yamaha 175 - Bogging down after running

I strongly second the idea of using a portable tank with new, clean fuel. That can isolate the problem to the engine or the boat.
__________________
Common Sense is learning from your mistakes. Wisdom is learning from the other guy's mistakes.

Fr. Frank says:
Jesus liked fishing, too. He even walked on water to get to the boat!

Currently without a SeaCraft
(2) Pompano 12' fishing kayaks
'73 Cobia 18' prototype "Casting Skiff", 70hp Mercury
Reply With Quote
  #6  
Old 07-04-2008, 06:13 PM
skipjake04 skipjake04 is offline
Senior Member
 
Join Date: Sep 2007
Location: houston (Alvin),TX
Posts: 106
Default Re: 1988 Yamaha 175 - Bogging down after running

Does the bulb stay hard and how old is your fuel line?

another thought, I have only owned one Yamaha and is was only for a short time. Mine was shutting down almost to 1500-2000 rpms, no buzzer and it was a water issue. It was getting hot and the pistons were swelling.????? was told it was a safety issue to keep the motor from locking up.
Replaced all water components and ran fine. Atleast until I sucked up an ice bag and finished it off about two months later.
__________________
SkipJake
1972 20 S.F , merc 97 150 offshore
Reply With Quote
  #7  
Old 07-06-2008, 10:44 AM
Ed Ed is offline
Senior Member
 
Join Date: May 2002
Location: Boston
Posts: 1,014
Default Re: 1988 Yamaha 175 - Bogging down after running

Does a 1988 175 Yammie have a VST tank? If so, you may want to check the filter on it. Dirty VST filters cause the engines to bog down in the mid rpm range.
Reply With Quote
  #8  
Old 07-06-2008, 11:40 AM
Rich Rich is offline
Senior Member
 
Join Date: Mar 2002
Location: Cape Cod
Posts: 622
Default Re: 1988 Yamaha 175 - Bogging down after running

I used an external tank with fresh gas and the same problem exists. When first started it will run nicely and will move out good, can reach up to 5400 rpm. After running for a minute or so, and after the engine warms up, it starts to bog down. Feels like not all cylinders are firing. It gets progressively worse as I run. At that point it can't get above 3900 - 4000 rpm. A new development last time I was out, it seems I can get a whiff of what smells like melting electrical wire coming from under the cowling.

Anyone know of a good Yamaha Mechanic down near or on the Cape?
__________________
Cape Marine Supply
Reply With Quote
  #9  
Old 07-06-2008, 12:38 PM
76Red18 76Red18 is offline
Senior Member
 
Join Date: Apr 2007
Location: NORTH FORT MYERS, FL.
Posts: 671
Default Re: 1988 Yamaha 175 - Bogging down after running

If you can get the engine warmed up at night when it is completly dark, take off the cowling and see if their is any "fire works" around the plug wires (bad plug wires leaking electricity to a ground)
__________________
" I'm the one thats got to die when its time for me to die; so let me live my life, the way I want to".
J. M. Hendrix
Reply With Quote
  #10  
Old 07-12-2008, 08:34 PM
Hookdude Hookdude is offline
Member
 
Join Date: Sep 2002
Location: Rockland, MA
Posts: 51
Default Re: 1988 Yamaha 175 - Bogging down after running

Rich,

Try Peter Olsen at Bayside Marine in Westport. He's a great guy, and really up on the Yammies.

My cell phone took a swim so I don't have his number handy but it should be listed. If not let me know and I'll find it for you.

Cheers,
Bob
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:34 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft