Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 04-17-2011, 09:53 PM
bdeep bdeep is offline
Junior Member
 
Join Date: Apr 2011
Posts: 4
Default bracket question

I have a 1974 20 center console with a yamaha f150 with a 20 inch shaft. It takes a fair amount of water over the back and I would like to mount a bracket and enclose the transom. Has anybody put a bracket on a 20 with a similar motor(440lbs)? As it is motor sits on the transom at it's original hight. Any insite would be appriciated.
Reply With Quote
  #2  
Old 04-17-2011, 10:02 PM
BigLew BigLew is offline
Senior Member
 
Join Date: Jan 2007
Location: Newburyport Area; Massachusetts
Posts: 1,364
Default Re: bracket question

Check out Strick's "Here we go again!" thread. He built his own bracket and takes you on a trip both down and up refurbville like no other person to my knowledge. Worth ten time the time it takes to read it! I think it's close to a thousand or more entries.

Good luck and keep us informed.
__________________
Getting home is more important than getting there!

Plan accordingly!
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft