23 cc configuration

Rlbol · #1 05-12-2009, 09:04 PM

So I basically have a blank canvas and am trying to figure out how I would like my Seacraft to be laid out. It is an enclosed transom originally I/O. There is currently no live well. I guess there was a factory live well in the floor below the leaning post. It is currently a very large fish box with I believe a threw hull transducer mounted below the pick up plumbing. I have been thinking about either replacing the leaning post with a above deck live well/leaning post or building a live well in the center of the transom similar to the sea vee boats. the transom below the doors is completely open other then the bracing of the transom to the hull. If anyone has pictures of there closed transom set up, would you please post them?
thanks!!

fdheld34 · #2 05-12-2009, 09:14 PM

Visit Don's site.......
www.hermco.net

Rlbol · #3 05-12-2009, 10:24 PM

I think I am going to have to take a drive this week and visit him!
I hope he is not to busy

kneedeep · #4 05-20-2009, 02:06 PM

ribol, i liked the see vee livewell setup too,i used it in my sceptre conversion project.photos in slideshow above

Rlbol · #5 05-20-2009, 09:58 PM

KneeDeep, where are the pictures of your boat? would love to see them!

kneedeep · #6 05-20-2009, 10:28 PM

rlbol there in the repair/mod section under sceptre to cc converion,you'll have to type in the photobucket link.

Rlbol · #7 05-20-2009, 09:57 PM

Quote:

Visit Don's site.......
www.hermco.net

I am going to go up there tomorrow. I am also going to try and go by armstrong as well as Wildfire Marine. There was also a place in stuart or that area that sold either used or surplus consoles and leaning posts and hardware. I can not recall the name nor could i find it under a search here. If anyone knows the place I am talking about could you please post it here for me!
thanks

waytogo · #8 05-26-2009, 10:59 AM

Check craigslist florida.There was a pathfinder console for 425.00,I just do not remember what area.

RWatts23 · #9 05-28-2009, 04:35 PM

I just installed a 45 gal. leaning post/well in my boat, cost around 900 new shipped to TX from Sebring area FL. I was back and forth between the transom well and leaning post combo, due to weight issues, I opted for the LP.When I figure out how to post pics, I'll post some.

Rlbol · #10 05-29-2009, 10:20 AM

Please post the pictures when you can!